How do I edit RAW html in WB15???

[QQQ]

I have an old web page and when I import pages into WB15 it also imports all the old SEO mistakes that I must remove and or edit.
I know I can ADD html data chuncks with the HTML TOOL but how do I get deeper into the full/raw HTML data of WS15 to get rid
of old garbage like this:

</html><META NAME="description" CONTENT="DIY wind generators and solar panel grid tie systems kits off grid energy system by thermodyne systems" /><META NAME="keywords" CONTENT="wind, generators, permanent, magnet, PMA, PMG, alternators, grid, tie, power, energy, solar, panels heater horse heater stop Cold Weather Colicing dog Colic 24V 24 stock Submersible VDC tank 24 cattle12V waterheater 24 volt Hot Water 48 RITCHIE animal Miraco lilspring Miraco livestock" />

From page - http://windturbineusa.com/

Any help very much appreciated.
Thanks

[BaconFries]

Just as the previous software you used WYSIWYG Web Builder 15 is not a HTML Editor. So to remove any HTML you will need to make the changes in a external HTML Editor such as Note Pad ++ or similar then import back into the program.

[QQQ]

I did find a few places where I could get access like going to PAGE VIEW mode and then "VIEW END" TAB and it all opened. I deleted it and then used the TAG tool and did it right.